I'm replacing the differential in a 2014 CX-9, and a couple of the bushings are in poor shape.

One of the rear bushings in the suspension crossmember is bad. I'm having trouble finding a part number for it. Does anyone have that, and can anyone recommend a tool to remove & install it?

The right mount bushing is bad (on both the old diff and the replacement). The entire mount is $150, and I'm having trouble finding a part number for just the bushing. Does anyone have that?

 

Update: I have the part numbers (aftermarket Febest), now just looking for tool recommendations for the crossmember bushing.

 

Do you happen to have a link or part numbers for the bushings? I'm in the same boat with my 2014

 

The side bushings are Febest MZMB-031. They went in with some difficulty.

The rear bushings I got are Febest MZAB-143. They would NOT go in. I spent 5 hours on one, with good tools. It was 0.7mm too big. Researching later, I learned that people had ground it down to fit.

Other people used Ford 7T4Z4B425B, which is apparently also too snug a fit but easier to trim.

 

Thank you! Much appreciated!

 

Part # 49255 - NOLATHANE REAR DIFFERENTIAL MOUNT BUSHING KIT

Part # SPF5108K Superpro Diff Mount Bush Kit