Okay Forum:
I've searched high and low.....
Multiple sights....I have posted on this forum under the Mazda 5 board.......

"Where can I run my Power Cable through the Firewall"

I cant find anywhere....People say remove the glovebox......

Where are their instructions????

It's not like I haven't researched myself for about a week now......



Tips? Pictures?

Thanks!

 

I have instructions for a Mazda 6 glove box removal, i'm sure they are pretty close.
If not check your owner's manual.

Click on: https://www.mazdaforum.com/forum/maz...zda-6-a-28561/

Don't forget to run an extra ground from the battery to vehicle body as well!

 

There is no instructions for the Mazda 5 in my manual.....
People keep talking about behind the pedals.......

I don't see it.....

Am I crazy or is this power cord the hardest part of this whole install?

 

Can you peel the carpet/insulation back from behind the pedal from the inside, and from the outside remove the battery? Removing the battery should give you a better view. Then you can drill a hole and put a grommet around the wire going thru (or silicone would suffice).

 

I don't own a drill lol.....
Sad I know

any other suggestions.......

I did see a huge bundle of wires on the passenger side of the hood with a silcone-grommet

Can I poke through that?

Im out of ideas lol

 

Hell my power wire went through the firewall under the glovebox. There is a plastic cover for wiring from the electronic's to the engine and it had a rubber guard. Took that off and it went in. Find out if there is one for your car.