Hey guys, I removed the rear wiper motor because the shaft was rusted and seized, I took it apart cleaned it, applied synthetic grease to the gears, reassembled it,
and still didn't work. I do have 12V dc going to the motor and I can hear clicking , checked the wiper fuses and are good, but it doesn't turn.
So I ordered a replacement from Rock auto, installed it and the new motor doesn't turn on setting1 and sprays on setting 2, I'm assuming that it's possibly not configured
the same as the original. Just wondering if someone has the wiring diagram? these motors had a circuit board module connected to the plug, so I'd like to know if I can rewire the plug wires
or if I should just go ahead and return the motor for a refund. Also, this should be the same as the Ford Escape wiring, its essentially the same vehicle but I can't find the diagram anywhere.

thanks in advance