When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have been searching the internet and haven't found any DIY guides or advice in removing the center command ****(in between the cup holders/shifter) on a 2017 CX-5. I found many guides for the 2016 and earlier models, but the consoles are a bit different with the 2017 model vs the 2013.5-2016 models.
The reason for all this is that I accidentally spilled a container of sauce on some of the buttons on the Command **** and would like to clean it all out. I did my best with cleaning the the buttons from the top, but need to get under the music control buttons/parking brake switch to clean it further.
Can anyone help me with a DIY guide/advice/video on how I would go about removing the Command ****? Any help will be greatly appreciated!
I have attached a photo below of the command **** I am referring to.
Have a look at these diagrams. No screws or bolts.
Perfect - thank you for posting for your feedback and for posting the diagrams! I was able to take off the command **** and the clean all of the buttons to where it's working like before. The whole process took no longer then 30 minutes.
Last edited by jakethelab; Jul 10, 2018 at 06:24 PM.
Hi , sorry for late posting maybe someone will answer , i can't seem to find any instructions on how to remove the command **** for my mazda, it is a cx5 2012 skyactive , it looks different from everything i have seen on the internet. The commands stopped working and i would like to check underneath and see if there is something wrong with the wires.
Can anyone help with an instruction for this model?
Thanks
Last edited by Sabin Cozma; May 28, 2019 at 03:48 AM.
2017 CX-5 Center Command **** Removal?
, i can't seem to find any instructions on how to remove the command **** for my mazda, it is a cx5 2012 skyactive , it looks different from everything i have seen on the internet. The commands stopped working and i would like to check underneath and see if there is something wrong with the wires.
