Cdwesley
#1
Cdwesley
I have a 92 2600i and I need help. I have put a idle air control valve on it, I have tried all the sensors and I have even installed another computer. Today drove it to work and before I could get out of the driveway it started to idle up again. Get to work, when I went to leave work it cranked and shut off immediately had to wait about five minutes and then it cranked, with an initial bogging down, gave some gas and made it home. Now it is sitting out in the drive and will not start. I am very frustrated having spent a bunch of money on this thing and I am right back where I started. Can somebody help me,please? Ready to put a stick of dynamite under it, at this rate the fuse would burn out before it exploded
#2
Welcome to the forum. Hopefully someone with more mechanical knowledge comes along to help. You may need to post in the appropriate section if you don’t get help here.
I had an 86 B2000 and loved it. Hopefully you can get yours back on the road.
I had an 86 B2000 and loved it. Hopefully you can get yours back on the road.
Thread
Thread Starter
Forum
Replies
Last Post