ECM Diagnostic Port - HELP ?
#1
ECM Diagnostic Port - HELP ?
Hello
I cannot seem to get the ECM Diagnostic port to work
That is, read out the OBD-I codes.
I have a:
-
Mazda 626
93 Automatic
Australia
Does not have a CEL (Check Engine Light) on the Dash.
Method:
-
1) Located Diagnosic Port ( See attached image )
2) Connected TEN (Test Engine) to GND (Ground) on Diagnostic connector.
3) Connected FEN to 12V Test Light and Ground on Diagnostic connectr.
4) Turned Ignition Key to ON.
-> Nothing happens ie. no 12V Test Light activity
Any help here would be appreciated.
Thanks
[IMG]local://upfiles/19890/A85819C178F140A4B545E4D1EEE4C62A.jpg[/IMG]
I cannot seem to get the ECM Diagnostic port to work
That is, read out the OBD-I codes.
I have a:
-
Mazda 626
93 Automatic
Australia
Does not have a CEL (Check Engine Light) on the Dash.
Method:
-
1) Located Diagnosic Port ( See attached image )
2) Connected TEN (Test Engine) to GND (Ground) on Diagnostic connector.
3) Connected FEN to 12V Test Light and Ground on Diagnostic connectr.
4) Turned Ignition Key to ON.
-> Nothing happens ie. no 12V Test Light activity
Any help here would be appreciated.
Thanks
[IMG]local://upfiles/19890/A85819C178F140A4B545E4D1EEE4C62A.jpg[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post
luchejko1
Mazda 323,Mazda 626 & Mazda 929
3
05-12-2006 08:05 PM