Anyone have a diagram of rear 626 brakes
#2
RE: Anyone have a diagram of rear 626 brakes
Have you removed the two #3 phillips screws that hold the drum onto the hub Sometimes are very tight and require the use of an impact driver. #2 in diagram below. It is not necessary to remove the center cap or large nut in the middle either. If you have already removed the two screws then is probably just rusted on a few sharp, outward blows on the outer edge of the drum with hammer and dull chisel should knock it loose.
[IMG]local://upfiles/1377/6751B30F8BF6419A8372A7DE50CA2BEE.gif[/IMG]
[IMG]local://upfiles/1377/6751B30F8BF6419A8372A7DE50CA2BEE.gif[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post
NelsonGTX
General Tech
1
03-04-2012 12:33 PM
Stevoh
Mazda Millenia
3
06-21-2010 03:17 AM
stasha
Mazda RX-7
0
11-02-2008 01:43 PM
js1736
Mazda 323,Mazda 626 & Mazda 929
0
02-27-2008 09:04 PM