egr wiring harness
#1
egr wiring harness
I just finished putting my engine in my car with new gaskets and everything was looking good till I went to start it up. sounded like a bad misfire and barely can idle, I was able to get a code that said to check the exhaust gas recirculation(egr) circuit when I did I noticed 3 out of the 6 wires on the egr connector were pulled out of the connector.
can anyone tell me the wiring pattern or have a picture that may help in rewiring the connector. even possibly know where I can get a connector to splice in to replace it with?
can anyone tell me the wiring pattern or have a picture that may help in rewiring the connector. even possibly know where I can get a connector to splice in to replace it with?
#2
Thread
Thread Starter
Forum
Replies
Last Post
Alucard
Mazda 323,Mazda 626 & Mazda 929
2
07-09-2006 01:01 AM
hockeytribute
Mazda Tribute
0
03-27-2006 06:24 PM