From my understanding its very hard to find front crossmember (or transverse member) and the rear tie bar in aluminum. I was able to get a set from a friend and remake them pretty much.

so i pretty much just wanna test out the water, see if its worth me making a few or not cuz there is a bit of work to get a set done.

here is some pics of the front cross member and i dont have pics of the rear tie bar, tho i could take some




*edit*
The rear tie bar fits all years. both V6 and the 4 banger.
The front crossmember fits all years for the V6, NOT the 4 cyclinder

 

That"s some nice lookin" work there, Blazn", but you forgot to include what years/engine/drivetrain they fit... unless they would fit all??
I had tomove this to a more appropriate area of the forum. The For Sale section not for gaging interest.

And remember that to sell your wares here, you must first apply for vendor or AVM status. You can find that form on the Sponsors page. See theupper RH sideof this page for a direct link. *Sponsors*

 

thanks for moving it and ill sign up for the vendor thang too

i found out that the rear tie bar fits all years. both V6 and the 4 banger. The front crossmember fits all years for the V6, NOT the 4 cyclinder

 

Who did the engineering behind this design? Was it a direct copy? What kind of aluminum did you use?

 

Hmmmm.... Good questions Blazn. VERY good questions, jokesing09.

 

i used 6061 aluminum and the part is a replica of the original

rear tie bar:
http://i28.photobucket.com/albums/c2...9231650000.jpg

 

bump