2003 Mazda 6 with 2.3L
#12
11-15-2014, 03:59 PM
For a 2.3 Mazda 6 you will need 1/4" socket set, Flexi magnet.
It would pay to replace the o-rings/manifold seals too.
Its a pain in the **** job. When you go to refit the manifold, pack a bit of paper or tape around the bolts so they are a tight fit in the socket when you go to refit them. You will understand why later.
It would pay to replace the o-rings/manifold seals too.
Its a pain in the **** job. When you go to refit the manifold, pack a bit of paper or tape around the bolts so they are a tight fit in the socket when you go to refit them. You will understand why later.
Good idea. I looked into the bay and I couldn't even seen that damned middle bolt. All the tool shops around me don't have any of the tools right now so it seems I need to either put this off for later or have it fixed by mechanic.
Thanks though!
Thread
Thread Starter
Forum
Replies
Last Post
