Aftermarket reversa camera - issues
Thread Starter
|
Junior Member
Joined: May 2019
Posts: 1
Likes: 0
From: Wales
Aftermarket reversa camera - issues
I have installed a reverse/backup camera in my 2015 Mazda 6 2.0 SE-L 65 plate (Great Britain). However, I'm having a few issues. The camera is powered by the ACC line via a fuse tap and the camera does get detected. However, the image is fuzzy and looks like a chewed up VHS tape.
I'm using a Connects2 CAM-MZ1-AD Additional Camera Add On Car Interface, link here - https://www.ebay.co.uk/itm/372486368042?ul_noapp=true
Along with a PARKVISION PRO Series Front/Rear View Backup Camera, link here -
I've tried two different Connects2 interface cables and two different reverse cameras but get the same issue. I'm of the thinking that the factory headunit is PAL version but the cable and camera only supports NTSC. Not sure if anyone has come across this before?
I'm using a Connects2 CAM-MZ1-AD Additional Camera Add On Car Interface, link here - https://www.ebay.co.uk/itm/372486368042?ul_noapp=true
Along with a PARKVISION PRO Series Front/Rear View Backup Camera, link here -
I've tried two different Connects2 interface cables and two different reverse cameras but get the same issue. I'm of the thinking that the factory headunit is PAL version but the cable and camera only supports NTSC. Not sure if anyone has come across this before?
Thread
Thread Starter
Forum
Replies
Last Post
dc5_dy
Audio/Visual Electronics
7
Jan 18, 2015 03:42 PM
