Hello, I had to replace my crank pulley due to damaged teeth. I replaced it and need to know where to align it. I know that the crank and the valve train are "fixed" in place with the crank pulley bolt. I have tested all cylinders for compression and they test fine. I couldnt mark the teeth of the old pulley teeth to see where the went due to damage. I just need to know where to align the crank pulley teeth to the sensor. The pulley has a white mark on one tooth but no mark on the engine to align it. I need to fix this in a hurry because I am in the military and need to drive cross country for a family emergency. Any help would be greatly appreciated. Thank you very much.