2006 suspension or transmission
Thread Starter
|
Junior Member
Joined: May 2025
Posts: 1
Likes: 0
2006 suspension or transmission
So I have a 2006 Mazda 3. It makes clunking, kinda clicking sounds coming from front driver side wheel. Any bumps are real bad. I've replaced struts, control arm, sway links, tie rods,.. then I was changing the axle. It was pretty loose. But stuck tight in the hub. Broke it in half trying to get it out. I was cleaning the area where it goes into the transmission, noticed the spinal were kinda wiggly. I installed the new axle. It's still too loose. Still making noise just a little less. Looking for any input
Ty
Ty
Senior Member
Joined: Oct 2018
Posts: 10,664
Likes: 233
From: Northern California
Welcome to the forum.
You may want to go to a Firestone in your area and have it inspcted. They should be able to indicate the exact problem and then you can DIY service it.
But to internet diagnose it all you are going to get are all the possible service areas to look at which seems you did most all of them. The thing you likely can't do is raise you Mazda on a lift that drops the suspension down and do an inspection.
You may want to go to a Firestone in your area and have it inspcted. They should be able to indicate the exact problem and then you can DIY service it.
But to internet diagnose it all you are going to get are all the possible service areas to look at which seems you did most all of them. The thing you likely can't do is raise you Mazda on a lift that drops the suspension down and do an inspection.
Thread
Thread Starter
Forum
Replies
Last Post
Bayou Barbie
Mazda3
1
Sep 10, 2023 09:14 AM
