Hooking up a Tach to 1996 Protege
#1
Hooking up a Tach to 1996 Protege
Ok so maybe I'm just incompetent. I'm trying to find the tach signal wire on my car.
Every thing i come across says white wire on distributor. Great right? No.
So looking on the distributor there are 4 harnesses on it and 3 out of 4 of them have a white wire. Which one is it? Does anyone know?
There are two harness under the distributor cap and one on top and one on the back side.
Harness underneath has 4 wires each (one of these connects to the o2 sensor i believe)
Top harness has lik 7-8 wires
Backside (connects straight into distributor cap) 3 wires - Car doesnt turnover when this one is disconnected but tries to start.
Any help is appreciated.
also anyone know of a good way to push a wire through the existing hole for the firewall?
Every thing i come across says white wire on distributor. Great right? No.
So looking on the distributor there are 4 harnesses on it and 3 out of 4 of them have a white wire. Which one is it? Does anyone know?
There are two harness under the distributor cap and one on top and one on the back side.
Harness underneath has 4 wires each (one of these connects to the o2 sensor i believe)
Top harness has lik 7-8 wires
Backside (connects straight into distributor cap) 3 wires - Car doesnt turnover when this one is disconnected but tries to start.
Any help is appreciated.
also anyone know of a good way to push a wire through the existing hole for the firewall?
Thread
Thread Starter
Forum
Replies
Last Post
dc5_dy
Audio/Visual Electronics
7
01-18-2015 03:42 PM
jaimie08mazda3
Audio/Visual Electronics
16
01-31-2012 08:15 AM