Hey guys im new to this, but my friend has a 2000 mazda millenia and his oil is a little milky and it will run but starts to over heat. So were going to replace the head gaskets and have the heads checked and possible resurfaced. so for my quesion, is there any write ups or how to's on the head gasket replacement? if not how tough will this be i've worked on cars alot but i've only done a spark plug change on a mazda before. Also will the supercharger have to come off as well or just all the pipes? thanks guys!

 

anyone?

 

Replace the motor

 

I you watn to do the heads here is a manual.

milleniatech.net - Documentation

This site is good but some of the links are old
milleniatech.net

 

Hello this is my frist time useing the forum. But I have a problem, I replaced my 2.3 Miller Eng. with another Eng. now this eng. just, after putting it in the car, the car over heated, and now it runs good until it get to warms up to normel tempture then it goes into limp mode them it won't then the fastes it goes is 30 mph. it also has bubbles coming though the water resavore what could it be could the catalic converter