I was reading on here about the ironman 2.5" suspension lift that in order to make the truck level they had to remove a couple springs from the rear leaf pack. i just purchased this kit and was wondering how many springs they had to remove to make it sit level. If so i'd like to see some pictures of some mazda 4x4s with this kit installed. thanks -Jordan

 

well i read the other ironman lift page and found out how many springs to remove, but once you remove those 3 springs what did you use for a bolt since it is only threaded so far? I also removed my stock drivers side torsion bar and had no problem taking off the one end, (the one that connects to the lower control arm), but wasnt able to get the other end off, anybody able to help me with this? i had to put everything back together just so i could drive it until i figure it all out. if anybody can help it would be much appreciated.