MAZDA MX 3 immobiliser
#1
MAZDA MX 3 immobiliser
Hello,
I'm new to this website but wondered if someone could help me please
I have a R reg mx 3 1.8 V6 and the immobiliser went faulty
so I bought another car which was scrap which ran and drove
I removed the ecu and ignition barrel but now I still have the same
fault as where you turn ignition on and the light on steering wheel
comes on and stays on but wait 5 seconds and then the light starts flashing
and the vehicle still fails to start
is there any way I can by-pass the immobiliser?
any help will be appreciated
Thanks kane
I'm new to this website but wondered if someone could help me please
I have a R reg mx 3 1.8 V6 and the immobiliser went faulty
so I bought another car which was scrap which ran and drove
I removed the ecu and ignition barrel but now I still have the same
fault as where you turn ignition on and the light on steering wheel
comes on and stays on but wait 5 seconds and then the light starts flashing
and the vehicle still fails to start
is there any way I can by-pass the immobiliser?
any help will be appreciated
Thanks kane
Thread
Thread Starter
Forum
Replies
Last Post
thaiball
Electronics, Computer & Fuel Systems
0
11-18-2010 03:34 PM