Gday, My 2013 3.2Lt BT50 continually goes into Limp Mode at 2000 revs, the scanned code indicates PO341-62, Have replaced the Camshaft Position Sensor and cleared the code with no luck, the car is becoming more sluggish to drive. I need to know what voltage is required at the sensor to check if its getting the correct signal please ????

 

Just checking, this is the sensor in the side of the head, just below the fuel rail, beside the EGR valve?

 

Don't have any figgures, but, try this

INSPECT CMP SENSOR CIRCUIT FOR OPEN CIRCUIT
• Switch the ignition to OFF.
• CMP sensor and PCM connectors are disconnected.
• Inspect for continuity between the following terminals (wiring harness-side):
― CMP sensor terminal 1 and PCM terminal C2
― CMP sensor terminal 2 and PCM terminal K3
― CMP sensor terminal 3 and PCM terminal D1
• Is there continuity?

 

Yes mate

 

What does the 6 7 8 mean on the diagram ??

 

Not sure, don't worry about that detail.

 

This plug connector is not the same as whats on my ECU, i cannot check continuity until i have the correct plug diagram, thanx anyway, Cheers

 

There will be 3 different plugs on your ECU.

 

Yes thats correct, none of them replicate your diagram below, so could not check continuity

 

Hi Chris, what ended up being the fault with this BT50 ? I have one doing exactly that.