Air fuel ratio sensor
2009 - CX-7 - Engine
AIR FUEL RATIO (A/F) SENSOR, HEATED OXYGEN SENSOR (HO2S) INSPECTION [L3 WITH TC]
NOTE:
•Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL.)
A/F Sensor Current Inspection
1. Warm up the engine to normal operating temperature.
2. Using the M-MDS, monitor the following:
◾Vehicle speed (PID: VSS)
◾Engine speed (PID: RPM)
◾A/F sensor current (PID: O2S11)
3. Drive the vehicle and decelerate the engine speed by releasing the accelerator pedal fully when the engine speed is 3,000 rpm or more.
4. Verify that the A/F sensor current (PID: O2S11) is 0.25 mA or more while decelerating as shown in the figure.
Here shipo, just pulled a few lines from a TSB that mentions the A/F. Made me look twice when I first came across the reference myself. The A/F translates it's information in mA.
AIR FUEL RATIO (A/F) SENSOR, HEATED OXYGEN SENSOR (HO2S) INSPECTION [L3 WITH TC]
NOTE:
•Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL.)
A/F Sensor Current Inspection
1. Warm up the engine to normal operating temperature.
2. Using the M-MDS, monitor the following:
◾Vehicle speed (PID: VSS)
◾Engine speed (PID: RPM)
◾A/F sensor current (PID: O2S11)
3. Drive the vehicle and decelerate the engine speed by releasing the accelerator pedal fully when the engine speed is 3,000 rpm or more.
4. Verify that the A/F sensor current (PID: O2S11) is 0.25 mA or more while decelerating as shown in the figure.
Here shipo, just pulled a few lines from a TSB that mentions the A/F. Made me look twice when I first came across the reference myself. The A/F translates it's information in mA.
Thread
Thread Starter
Forum
Replies
Last Post



