89 mazda b2200 bellhousing seal do not match up with hole.
#1
89 mazda b2200 bellhousing seal do not match up with hole.
Hi, I am trying to install a new clutch on 89 mazda b2200 se5. I got everything out but when I went to install it, the metal seal between the engine and the bell housing wont line up with the holes. I think metal seal is in two pieces. it's the two bottom right holes. I tried to take the flywheel off but the screw driver fly's out and hits me in the face. what do I need to do? do I need to take the flywheel off and reline the seal? did I do something bad? please help!!!!!!!!
Last edited by sphinxx187; 10-01-2009 at 04:32 PM.
Thread
Thread Starter
Forum
Replies
Last Post
SpeedLover
Wheels, Tires and other Exterior
0
12-02-2010 06:41 PM
krackerx7
Mazda BT 50 & Pickup Trucks
4
09-17-2006 08:29 PM