CX-5 2.2D Rear Brake Caliper Problem
Thread Starter
|
Junior Member
Joined: Mar 2020
Posts: 1
Likes: 0
From: Durban
CX-5 2.2D Rear Brake Caliper Problem
Currently under lock down here, so decided it would be a good time to change the brake pads on my CX5-2.2D with electronic park brake.
I only found out I had to put the EPB it into maintenance mode after I had removed the caliper. It seems that I messed it up and actually activated the parking brake with the caliper out, instead of releasing it. The piston has now been pushed out, to the extent that it seems that it has disconnected from the motor, in fact it may have dislodged the seal as a small amount of brake fluid has leaked out. I have tried releasing the brake but the motor just turns till eventually the EPB failure light comes on and the EPB light flashes.
Would appreciate any ideas on how I fix this?
I only found out I had to put the EPB it into maintenance mode after I had removed the caliper. It seems that I messed it up and actually activated the parking brake with the caliper out, instead of releasing it. The piston has now been pushed out, to the extent that it seems that it has disconnected from the motor, in fact it may have dislodged the seal as a small amount of brake fluid has leaked out. I have tried releasing the brake but the motor just turns till eventually the EPB failure light comes on and the EPB light flashes.
Would appreciate any ideas on how I fix this?
Junior Member
Joined: Sep 2020
Posts: 1
Likes: 0
From: Michigan
Currently under lock down here, so decided it would be a good time to change the brake pads on my CX5-2.2D with electronic park brake.
I only found out I had to put the EPB it into maintenance mode after I had removed the caliper. It seems that I messed it up and actually activated the parking brake with the caliper out, instead of releasing it. The piston has now been pushed out, to the extent that it seems that it has disconnected from the motor, in fact it may have dislodged the seal as a small amount of brake fluid has leaked out. I have tried releasing the brake but the motor just turns till eventually the EPB failure light comes on and the EPB light flashes.
Would appreciate any ideas on how I fix this?
I only found out I had to put the EPB it into maintenance mode after I had removed the caliper. It seems that I messed it up and actually activated the parking brake with the caliper out, instead of releasing it. The piston has now been pushed out, to the extent that it seems that it has disconnected from the motor, in fact it may have dislodged the seal as a small amount of brake fluid has leaked out. I have tried releasing the brake but the motor just turns till eventually the EPB failure light comes on and the EPB light flashes.
Would appreciate any ideas on how I fix this?
Junior Member
Joined: Feb 2017
Posts: 12
Likes: 0
From: Northbrook
If the piston is out all the way, do you just push the piston back in WITHOUT rotating the piston? I saw a picture with piston our and it looked like it had to be twisted in. Kinda like nut and screw putting together. I have 2017 CX9 with EPB
Super Moderator
Joined: May 2012
Posts: 7,848
Likes: 32
From: Queensland Australia
Refer to your own started Thread.
Thread
Thread Starter
Forum
Replies
Last Post
