Mazda CX-5 Service & Repair Manual: Light Switch Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Lighting & Horn / Sensors, Switches, Relays / Light Switch Removal/Installation

NOTE:

When removing the light switch, it is necessary to rotate the steering wheel. If the ignition is switched off from ON (engine on) with the driver's door closed, the steering wheel is locked. Therefore, perform the procedure in Steps 1 to 3 so that the steering wheel is not locked.

1. Switch the ignition ON (engine on).

2. Open the driver's door.

3. Switch the ignition to off.

4. Disconnect the negative battery cable..

5. Remove the column cover..

6. Rotate the steering wheel until the service hole in the position shown in the figure is visible.

7. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure.

8. While pressing the light switch tab in the direction of the arrow (1) shown in the figure using a flathead screwdriver, pull out the light switch in the direction of the arrow (2) shown in the figure to detach the light switch tab and the start stop unit.

9. Remove the light switch.

10. Install in the reverse order of removal.

Light Switch Inspection

Light Switch 1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the light switch.. 4. Verify that the continuity between the light switch terminals is as indicate ...

Exterior

...

Other materials:

Awd Control Module
Purpose, Function The AWD CM calculates the optimal amount of torque distribution for the rear wheels and outputs a corresponding electric current to the electronic control coupling (AWD solenoid). This calculation is based on the accelerator pedal angle, four-wheel speed, engine spe ...

Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor and measure the resistance between passenger compartment temperature sensor terminals A and B. If the characteristics of the passenger compartment temperature sensor are not as shown in the graph, replace t ...

Cruise Main Indicator Light (Amber)
Purpose/Function Illuminates while the cruise control system is in standby mode to inform the driver that the cruise control system is on standby. Construction Built into the instrument cluster. Operation Illuminates while the cruise control system is on sta ...