I need help!

Mazda Forum Mazda Classifieds Photo Gallery Member List Search Contact Us Sponsors
Models Mazda News Mazda Recalls TSBs Timeslips Register Login

I need help!

Printable Version

Mazda >> Mazda Vehicles >> Mazda Protege >> I need help!

Page: [1]

Message

<< Older Topic Newer Topic >>

I need help! - 3/14/2008 10:22:45 AM

ScarletNightshade

Posts: 1
Joined: 3/14/2008
Status: offline

Okay...first off I'm going to start out by saying that I'm not *great* with cars. My husband is out of town for a while and I needed to replace my drivers side CV axle on my '98 Protege.

The axle was pretty tough to get out and now the new one just WILL NOT go back in! I've tried and tried but not matter how hard I push it won't go down far enough to seal and everything.

I've got it lined up correctly and there's nothing that's blocking the trans-axle case (I think that's what it's called) that I can see - the axle on the passengers side is fine.

Are there any tips and tricks that might help me out - I really need my car to be fixed so I can get to work and I've been working on this for a day and a half already!

Post #: 1

RE: I need help! - 3/14/2008 10:34:06 AM

fortysixxand2

Posts: 54
Joined: 2/25/2008
Status: offline

WD-40 ALWAYS works wonders :).

_____________________________

(in reply to ScarletNightshade)

Post #: 2

RE: I need help! - 3/14/2008 4:45:07 PM

virgin1

Posts: 4970
Joined: 3/15/2007
Status: offline

It sounds like you may have gotten the wrong number of splines on the new axle.
Check it against the old one to see if the spines are coarser or finer than the new axle you have.

_____________________________