93 MX6 Clutch sticking and sinking

Mazda Forum Mazda Classifieds Photo Gallery Member List Search Contact Us Sponsors
Models Mazda News Mazda Recalls TSBs Timeslips Register Login

93 MX6 Clutch sticking and sinking

Printable Version

Mazda Forums >> Mazda Vehicles >> Mazda Mx-3 and Mazda Mx-6 >> 93 MX6 Clutch sticking and sinking

Page: [1]

Message

<< Older Topic Newer Topic >>

93 MX6 Clutch sticking and sinking - 12/13/2007 1:31:45 PM

JanMan77

Posts: 1
Joined: 12/13/2007
Status: offline

I have had my mx6 for about 3 months now. A few weeks ago the pedal started to squeak. Then just about 3 or 4 days ago the pedal would stick when it was fully pressed. I had to start pulling it back up with my foot, then it would work just fine. I then sprayed grease up onto the return spring. Yesterday the pedal stuck but was a lot harder to pull back. When ever I put it in gear (with the clutch pushed in) the clutch catches and kills the car within 2 seconds..but the clutch is still pushed down. When i am driving..after i shift and let go of the clutch, and pull it back out with my foot..the pedal starts to sink back to the floor. once the pedal is back to the floor it still acts as if the clutch is not pushed down. I have checked the master cylinder but there is no leaking anywhere. Where should i look and what should i test? should i actually pull the master cylinder and inspect it? thanks

Post #: 1

RE: 93 MX6 Clutch sticking and sinking - 3/5/2008 3:00:27 PM

95mx6

Posts: 2
Joined: 3/5/2008
Status: offline

did you bleed the cluch

(in reply to JanMan77)

Post #: 2

RE: 93 MX6 Clutch sticking and sinking - 3/6/2008 5:04:27 PM

Joeys88Mx6

Posts: 2
Joined: 7/19/2007
Status: offline

Check Your clutch slave Cylinder my 1st gen 6 was doing that a few months ago and I left me stuck at a light and I had it changed out on my lunch it really easy on the 1st gen am not so sure about a 93 though but the piece was only like 28-29 dollars but let me know if you figured it out.... -Joey

(in reply to 95mx6)

Post #: 3