93 MX6 Clutch sticking and sinking (Full Version)

Mazda >> Mazda Vehicles >> Mazda Mx-3 and Mazda Mx-6

93 MX6 Clutch sticking and sinking


  

JanMan77 -> 93 MX6 Clutch sticking and sinking (12/13/2007 1:31:45 PM)

I have had my mx6 for about 3 months now.  A few weeks ago the pedal started to squeak.  Then just about 3 or 4 days ago the pedal would stick when it was fully pressed.  I had to start pulling it back up with my foot, then it would work just fine.  I then sprayed grease up onto the return spring.  Yesterday the pedal stuck but was a lot harder to pull back.  When ever I put it in gear (with the clutch pushed in) the clutch catches and kills the car within 2 seconds..but the clutch is still pushed down.  When i am driving..after i shift and let go of the clutch, and pull it back out with my foot..the pedal starts to sink back to the floor.  once the pedal is back to the floor it still acts as if the clutch is not pushed down.  I have checked the master cylinder but there is no leaking anywhere.  Where should i look and what should i test?  should i actually pull the master cylinder and inspect it?  thanks


  

95mx6 -> RE: 93 MX6 Clutch sticking and sinking (3/5/2008 3:00:27 PM)

did you bleed the cluch[8|]


Joeys88Mx6 -> RE: 93 MX6 Clutch sticking and sinking (3/6/2008 5:04:27 PM)

Check Your clutch slave Cylinder my 1st gen 6 was doing that a few months ago and I left me stuck at a light and I had it changed out on my lunch it really easy on the 1st gen am not so sure about a 93 though but the piece was only like 28-29 dollars but let me know if you figured it out.... -Joey


  

Page: [1]

Return to Mazda Forum home page or view the Full Version of this page.