Would these rims fit?

Printable Version

Mazda Forum >> Mazda Vehicles >> Mazda3 >> Would these rims fit?

Page: [1] 2 3 4   next >   >>

Login Message << Older Topic   Newer Topic >>

Would these rims fit? - 11/21/2007 7:37:34 PM    bobbings   Posts: 3 Joined: 11/20/2007 Status: offline It's a 17" gunmetal 5zigen typhoon 17x8 bolt pattern: 5x114 offset: 43 I'm looking to pick up a used set from a fellow rsx owner. Hopefully it's okay with the 8 inches and the 43 offset. Also, one rim hit the curb slightly. Is that bad enough to just walk away from the deal? Thanks Also, these rims will come with a set of ziex 512 already mounted. The specs for the tires are: 215/45/r17 BTW, It's for a 2005 Mazda 3 GT Sport. Would it rub at all? Here's a pic of the rims: http://img.photobucket.com/albums/v710/1Darkchaos/side.jpg Thank you Post #: 1

RE: Would these rims fit? - 11/21/2007 8:00:31 PM    virgin1 Posts: 4933 Joined: 3/15/2007 Status: online   Nice looking rim, and if the price/deal is right it would be worth a try. 215's on an 8"?  The tire would only be <1/2" wider than the wheel width.  Could be a little narrow, but should work.  I had 215's on the OE 6.5" rims and they fit nicely. Also the 45 aspect ratio will make your speedo read higher than your actual ground speed. A 15.66 rev/mile difference, or about 1.27 mph difference @ 65mph... more the faster you'd go.  Less the slower. The 8" rim/+43mm offset (OE is +52.5mm, but w/a wider 8" wheel you might need the extra room behind) could pose a minor rubbing problem, imo.  'Might have to roll fender lips in order for them not too rub, especially w/weight in the car. Would you be allowed to try them before you commit to the deal? < Message edited by virgin1 -- 11/22/2007 6:26:13 AM > _____________________________ "There is no tool you can buy that will replace experience." - Josh Mills, C.K.DeLuxe (in reply to bobbings) Post #: 2

RE: Would these rims fit? - 11/22/2007 6:06:26 AM    jaimie08mazda3 Posts: 2061 Joined: 8/25/2007 Status: offline hmmm RSX rims for a mazda3... well tahts different. _____________________________ 2008 mazda3 GS 5spd Jaimie08mazda3:ricing out a 4 door integra is stupid Virgin1: and how many doors does your mazda3 have (in reply to virgin1) Post #: 3

RE: Would these rims fit? - 11/22/2007 7:58:57 AM    bobbings   Posts: 3 Joined: 11/20/2007 Status: offline Thanks for the replies. Yes I can try them on before I buy. How would I go about checking it if I put it on? (in reply to jaimie08mazda3) Post #: 4

RE: Would these rims fit? - 11/22/2007 8:13:34 AM    virgin1 Posts: 4933 Joined: 3/15/2007 Status: online Well, 1. with the car on the ground and the suspension settled in, put your hand behind the wheel to feel how much space is between it and the strut and other suspension component.  2.  Ask three or four friends to ride along w/you as you drive around bends and over bumps, etc... Common sense stuff mostly, but basically whatever you can think of that might challenge the suspension w/the new wheel/tire combination on it. .  _____________________________ "There is no tool you can buy that will replace experience." - Josh Mills, C.K.DeLuxe (in reply to bobbings) Post #: 5

RE: Would these rims fit? - 11/22/2007 8:27:27 AM    Siber Express Posts: 657 Joined: 11/14/2007 From: Clinton Tennessee Status: offline Here are the figures off of the Wheel offset Calculator The clearance from strut housing to the inside of the wheel will be 10mm LESS The outside edge of the wheel will EXTEND an extra 28mm http://marksink.com/tire_wheel_offset/offset.html You would want to check on the front from full lock to full lock to see if it is going to hit and on the front and rear to see if the fender is going to bottom out on the tires. _____________________________ 08 Mazda 3 s 5 Door Copper Red Mica 2.3 5 Speed M/T He Who Dies With The Most Toys Is Nonetheless DEAD. (in reply to bobbings) Post #: 6

RE: Would these rims fit? - 11/22/2007 8:36:04 AM    virgin1 Posts: 4933 Joined: 3/15/2007 Status: online   Nice link, Siber!!  I LOVE stuff like that.  Saved to favorites.  _____________________________ "There is no tool you can buy that will replace experience." - Josh Mills, C.K.DeLuxe (in reply to Siber Express) Post #: 7

RE: Would these rims fit? - 11/22/2007 8:43:13 AM    jaimie08mazda3 Posts: 2061 Joined: 8/25/2007 Status: offline nerd _____________________________ 2008 mazda3 GS 5spd Jaimie08mazda3:ricing out a 4 door integra is stupid Virgin1: and how many doors does your mazda3 have (in reply to virgin1) Post #: 8

RE: Would these rims fit? - 11/22/2007 8:56:47 AM    Siber Express Posts: 657 Joined: 11/14/2007 From: Clinton Tennessee Status: offline I found it on the M3 forums from a Link that icspots gave me on the stereo, lot of cool stuff over there, BTW I saved it also Jamie anything you can use once yourself and was tough to find is worth saving, someone down the road might need it and saving is a lot better than looking again. So not a Nerd, informed is the correct word < Message edited by Siber Express -- 11/22/2007 9:01:22 AM > _____________________________ 08 Mazda 3 s 5 Door Copper Red Mica 2.3 5 Speed M/T He Who Dies With The Most Toys Is Nonetheless DEAD. (in reply to jaimie08mazda3) Post #: 9

RE: Would these rims fit? - 11/22/2007 9:08:11 AM    virgin1 Posts: 4933 Joined: 3/15/2007 Status: online   My protector.  My savior.  I LOVE YOU Siber.  See!?!?  What HE said.  Here's another I use all the time... and  don't GIVE these to just anybody:  http://www.discounttire.com/dtcs/infoTireMath.dos _____________________________ "There is no tool you can buy that will replace experience." - Josh Mills, C.K.DeLuxe (in reply to Siber Express) Post #: 10

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Mazda Prices

Mazda
Mazda Miata MX5
Mazda 3
Mazda RX-7
Mazda RX-8

Top 10 Posters
virgin1 4933 babyhuey 2759 sstlaure 2343 jaimie08mazd 2061 tracker 2038 the_gray_maz 1874 87 turbo ii 1692 dentinger 1518 bkey71 1469 speedy3 1136

New Vendors
Sportwing
Med Center Mazda
AMSOIL - Performance Oil Technology