gas filling problem

Mazda Forum Mazda Classifieds Photo Gallery Member List Search Contact Us Sponsors
Models Mazda News Mazda Recalls TSBs Timeslips Register Login

gas filling problem

Printable Version

Mazda Forums >> Mazda Vehicles >> Mazda Tribute >> gas filling problem

Page: [1]

Message

<< Older Topic Newer Topic >>

gas filling problem - 11/5/2007 2:12:31 PM

te516358

Posts: 1
Joined: 11/5/2007
Status: offline

Recently I've found that I can't set the auto clip on the gas pump as it shuts off after a second. It even does that when I try to fill manually. Works a bit better if I reduce the pressure but still stops a lot. Tried different angles with the pump and different stations. Takes ages to fill up. Some kind of sensor? Can I fix it? This is a 2005 Tribute with no other problems.

Post #: 1

RE: gas filling problem - 11/5/2007 8:08:11 PM

hms365

Posts: 1
Joined: 11/5/2007
Status: offline

I also have a 2005 with that problem. When I turn the nozzle completely around, it will fill. The nozzle shutoff doesn't cut off right away, so you need to know about how much fuel is needed.

Hope somebody has an answer.

(in reply to te516358)

Post #: 2

RE: gas filling problem (Solution is here!) - 5/4/2008 8:45:04 PM

alexgarin

Posts: 2
Joined: 5/4/2008
Status: offline

Hi guys,

The problem is with the broken seal around tank breatherer that located on the bottom of the car. This is one of the many issues with Tribute, I had the same issue with 2006 GT. Here is how it works. Tank has 2 holes - one out (gas go to engine) and one in (to take air to compensate pressure). This in is going with the pipe under the car into small box with filter - this is how tank can breath. If the sealer on this box is broken - water gets inside, and when temperature is below 0 - boom, filter is frozen, cannot breath - cannot fill gas (because air cannot go out and gas pistol kicks out). Just go to Mazda dealership and ask them to re-seal this breatherer. Also tell them that this is known issue with many cars - may be you can get it fized for free. In my case it was under warranty so it was free, but it took for them some time to figure this out. I even had to take guy from dealership to gas station and show this problem because they did not believe me in first place.

Hope this will help you. I know it is warm now and this problem is gone, but next winter it will come back, trust me. So get it fixed when you can!

(in reply to hms365)

Post #: 3

RE: gas filling problem - 5/13/2008 11:50:20 AM

kev4x100

Posts: 2
Joined: 5/13/2008
Status: offline

This same thing happens quite often over the past 2 years with my tribute as well. Sometimes you can get it to work by monkeying around with how far the nozzle is in.

(in reply to te516358)

Post #: 4