Moddin my rx7

Mazda Forum Mazda Classifieds Photo Gallery Member List Search Contact Us Sponsors
Models Mazda News Mazda Recalls TSBs Timeslips Register Login

Moddin my rx7

Printable Version

Mazda >> Mazda Vehicles >> Mazda RX-7 >> Moddin my rx7

Page: [1]

Message

<< Older Topic Newer Topic >>

Moddin my rx7 - 10/28/2007 3:11:58 PM

z0mbie_king

Posts: 5
Joined: 10/28/2007
Status: offline

Im wantin to mod my rx7 n/a. I am not sure if this is in the right place but here I go. I know I am gonna need some new apex seals soon and I was wandering if there were some stronger seals that I can get to protect my engine better? Also I was wandering what all I can do to make some more hp. I figured if Im gonna have the engine apart then I might as well do some things to it so any sudgestions would be appreciated. I was wandering how much more power I could get out of the engine street porting it and what else I may beable to do to get 300is n/a.

Post #: 1

RE: Moddin my rx7 - 10/29/2007 5:35:30 AM

Mazmart Trini

Posts: 393
Joined: 10/1/2007
Status: online

If you are rebuilding the motor, you would probably want to put a street port on it. Also, I would probably rebuild with stock Mazda's Apex Seals especially on an NA. Then look into getting a header & exhaust system from Racingbeat

(in reply to z0mbie_king)

Post #: 2

RE: Moddin my rx7 - 10/29/2007 10:02:14 AM

z0mbie_king

Posts: 5
Joined: 10/28/2007
Status: offline

Im tryin to get atleast 300hp out of it. Its gonna be a show car but I also want it to have so go. I was wanderin about the aftermarket seals cause I was gonna turbo the engine later and maybe spray it. As for the street port how what exactly is it and about how much does it cost and can I get to 300 with the things you mentioned. I found a nic headder by pacesetter and there is a locka shop that can run the pipe off the header for me. Also I was told that a "unstreetable peripheral port" would be better, what is that too? Im not new to the rx7 just new to moddin them. Im tryin to figure out what I can do to get the 300rwhp and see what its gonna cost.

(in reply to z0mbie_king)

Post #: 3