|
Alpha Wolf -> Mazda Mask Installation... (1/21/2007 9:07:40 PM)
|
Installed the Mask today.
You need to replace one screw/clip in each front fender wheel well with one that has a snap on it.
Then it is just stretching and cliping on the hooks.
It comes with the opening for the front license plate and fog lights blocked off. To remove the fog light plugs you remove one series of threads holding the patches in place. I did not remove the one for the license plate as I have not mounted my front one.
You do have some tabs you must push between the bumber and the headlights and the grille and the bumper.
Looks nice but took a little longer than ones I have had on my Bug, Trans Am etc... in the past.
[image]local://upfiles/7731/7FFAEE98876347A5914F1E7059744435.jpg[/image]
|
|
|
|
