Truck Not Firing (Full Version)

Mazda >> Mazda Vehicles >> Mazda Pickup Trucks

Truck Not Firing

Mazdaboy2600i -> Truck Not Firing (12/24/2006 9:17:46 PM)
I pulled my engine, to put new gaskets all over it. I put it all back together, and had it running, but the timing was off a little bit. The distrubtor was maxed out turning it wise. So i pulled it out turned it a few notches, and put it back in. and not it it will not fire. The coil is getting fire. Its a brand new coil, and distbutor. new plugs, wires.. please help me out, i depend on this mazda for everyday use. its a 1989 Mazda B2600i 4x4. 2.6 Liter Fuel Injected.

monstermazda -> RE: Truck Not Firing (12/26/2006 3:11:21 AM)
did you reference the timing at all? im guessing its not even close now. try and get a timing light and make sure its on.

Mazdaboy2600i -> RE: Truck Not Firing (12/26/2006 8:24:06 PM)
I PULLED THE VALVE COVER OFF AND WATCHED THE CAMSHAFT GEAR AND DISTRUBUTOR.THE DOWEL PIN ON THE CAMSHAFT BROKE, AND ITS NOT TURNING THE DISTRUBUTOR GEAR. WOULD THAT MAKE IT NOT BE CRANKING??????

poorboy_616 -> RE: Truck Not Firing (12/26/2006 10:35:22 PM)
That'll do it....

Mazdaboy2600i -> RE: Truck Not Firing (12/28/2006 8:55:12 PM)
The dowel pin is a dealer item only..... Figures!!!!! 1 and a half weeks till i can get it... LoL About my timing. when i put the cam in.. how do i set the timing back to where it goes so it will run correctly. when i pulled the cam, i had the number 1 piston up to top dead center. What else???? this forum is awsome!

poorboy_616 -> RE: Truck Not Firing (1/2/2007 2:44:53 AM)
Do you have a GOOD repair manual handy? The instructions should be in the book...... Otherwise.... Here is another cool site that might help: http://www.mazdatruckin.com

Page: [1]

Return to Mazda Forum home page or view the Full Version of this page.