Has anyone taken out the stock bench seats and replaced with bucket seats. i am a noobie at this stuff and am looking for any help i can get. i have heard that the older ford sedans had seats that make nearly perfect replacements but i would like to know what to look for before i go "pick-a-part"ing.
Register today for free or log-in if already registered to remove this ad!
mine's a 91 b2600i reg cab bench took the interior out of an 88 2600 extended cab buckets and center console
the bolt hole's are already in the floor just need to cut the hole in the carpet for the frame of the seats http://www.cardomain.com/ride/2311787
mine's a 91 b2600i reg cab bench took the interior out of an 88 2600 extended cab buckets and center console
the bolt hole's are already in the floor just need to cut the hole in the carpet for the frame of the seats http://www.cardomain.com/ride/2311787
that looks good on the buckets but didnt the pics also state ya too the whole cab from the 882600? or was this after doing the seat/console swap out?
ahhh ok i thought ya went 2200 seats to a 2600 cab vice versa there... looks good, i wish i could find me a set of buckets in good shape for mine, accually i am thinking of parting her out and finding me a x-cab, even if the rugrats cant fit i know a few other things could go back there..
ahhh ok i thought ya went 2200 seats to a 2600 cab vice versa there... looks good, i wish i could find me a set of buckets in good shape for mine, accually i am thinking of parting her out and finding me a x-cab, even if the rugrats cant fit i know a few other things could go back there..
Almost perfect fit. One small mod to make it a direct bolt in. I need (even after 4 months) to swap (seat for seat) the inside rear mounting feet. The Neon feet are offset to the outside of the cab, while the Mazda feet are offset towards the hump.
Seats:
Not a great picture, but it does the job.....
Thank the wife for the "cheesy" leopard print.....
Mounting feet:
__________________
My Vehicles:
1987 B2000 Pickup 1994 Chrysler T&C minivan
School/work:
2 years Auto Tech. 1 yr Detroit Diesel Allison corp, 2 yrs Schuck's Auto supply, currently employer: NAPA Auto Parts, ASE Parts (P2)and ASE A/C Tech. Cert.
got these off of ebay. bolted through the floor with 4x4 plates on the underside of the cab. used 2x3 steel for the rear mounts, 1x1 tube in the front. had to get them up off the floor, the stock seats were way to low, and i like to be able to look out.
'88 mazda b2600 bucket seat conversion?
