Pull Mazda5 Headunit for XM FM mod intall

Bought a Mazda5--love it! Exceeded all my expectations. It's my fourth Mazda . . . Anyway, I want to install a direct FM modulator for my XM Roady2. Any idea on how to pull the headunit to reach the plugs on the back?

are you sure that there are input ports?

Do not rememer if has input port or not. Fairly easy to remove to check. Pull side panels down on inside of both footwell straight out. Remove the one visible phillips screw on each side. Pull the silver shifter cover straight up and remove. Two screws under this panel to remove as well. Now move shifter as far rearward as you can and pull the entire center console towards you and up. There are two clips in the upper center just below the a/c and recirc buttons that are kind of tight so be careful not to break console. Pull console out of the way and remove two phillips screws on bottom of audio unit. Pull audio unit straight out. Included some picts to show location of clips and screws.


Thumbnail Image



Thumbnail Image



Thumbnail Image



Thumbnail Image



Thumbnail Image

Thanks for the very detailed reply--exactly what I needed!!

Instructions for headunit are very accurate. And yes, there are inputs on the back for FM antenna. Thanks again!

Glad I good lend some assistance in r and r.

I took may radio out too installed a DVD input and a BTL too change from cables to RCA at the output of the original radio a pre-amp and a four channel Amps for the 4 speakers but i had to take the 5 too the dealer so my proyect is in hold and i will continue when they fix the problem