Cruise Control Trouble

My set/coast works- but the resume/accel  doesn't. Why? easy fix?

Hi again zmanzke.
 
Problem has to be within the actuator switch itself which is part of the wiper lever assembly. Both functions use the exact same 5 volt input wire from the cruise control module as well as the same ground wire. The difference is just in the way the switch changes the 5 volt input by routing the voltage thru either a 910 ohm resistor for resume/accel or a 240 ohm resistor for set/coast.
Replacement of the wiper lever assembly is going to be your only way to get it all working right again. Wish I had cruise on my 323. Sure is handy on long drives.

Well, it is all working now. The fuel pump/sending units getting fixed next week, that was a bear finding one where I live.