cdnmazda
1/15/2007 9:06:31 AM
I have a 94 b 2300 4 cyl it starts awesome cold once warm it will not start sometimes. It has lots of spark when this happens and the piston top has gas sitting on it. If I let it sit for a day or two it will start up again no problem. I went through and cleaned most of the connections on all the wiring harness then used a silicone grease to seal them up to stop any other corrosion from happening. I was using the haynes manual to check the codes for the ecm but when I put in the jumper wire then turned the key on and engine off the check engine light does not flash it is just on solid. Also the same when I try the key on engine running test aswell. According to the book the light should flash to let me know whats wrong. My ABS light is also constantly on. Any help will be appreciated.
