mwce2
12/8/2006 12:22:29 AM
I dont know if these trucks do this or not but my clutch seems a bit slow when I release if I take my foot off of it fast there is a slight delay for it to return back up clutch holds just fin do I just need to lubricate something?
kallgrer
12/9/2006 10:24:54 PM
Since these trucks have hydraulic clutches, they need to be bled if any air gets in the line. Bleed your clutch just like you would your brakes. Make sure the clutch master cylinder is full and with the wheels chocked, have someone depress the clutch. When the clutch is in, cycle open and shut the bleeder screw that is on the slave cylinder which is located on the passenger side of the transmission, then release the clutch pedal. Repeat this process until no more air bubbles are visible in the fluid. Don't forget to hook up a tube to the fitting on the bleeder screw so you don't get brake fluid everywhere. Enjoy!
mazdab2600
12/14/2006 12:10:16 AM
quote:
ORIGINAL: mwce2
I dont know if these trucks do this or not but my clutch seems a bit slow when I release if I take my foot off of it fast there is a slight delay for it to return back up clutch holds just fin do I just need to lubricate something?
i noticed this just a weekago with mine but it was cold(-20c)
it only did it a few times (4-5) and only that morning
will keep you posted if it happens again and if i find anything
mwce2
12/14/2006 12:41:24 AM
Mine has done this far as long as I can remember.
