cayeb
12/19/2007 7:27:35 PM
MY TRUCK FAILED EMISSION TESTING TODAY ( NOX, CO & HC). I WAS ADVISED TO DO TIMING ON THE TRUCK FIRST. I HAVE A TIMING LIGHT AT HOME BUT I'M NOT SURE IF I'M DOING IT PROPERLY. ANYONE CAN ASSIST ME i WOULD REALLY APPRECIATE IT.
supratreo
12/19/2007 7:31:27 PM
first turn the crank so you can see the notch on the crank pully and put some bright paint on it so you can see it while the motor is running. then jump the diag. connecter and use your light to set the timing to 5 deg. (give or take 1 deg.) by turning the distributor. also check your idle at this time.
cayeb
12/20/2007 11:27:31 AM
thanks for the reply.Sorry for my ignorance but where is the diagnostic connector for this truck. Is there a proper way of jumping the connector
bigboss2010
12/20/2007 11:58:20 AM
the connector is located on the passenger side of the truck it is green in color, and as far as jumping if you have a manual it will tell you the proper way to do this.
cayeb
12/20/2007 7:57:37 PM
bigboss2010,
i found the connector but i don't have a manual to do the proper jumping. Any idea how to do it properly?
